How to Install Bathroom Shower: A DIY Guide

Shower installation can be a daunting task if you're not familiar with the process. In this DIY guide, we'll show you how to install a bathroom shower in just a few easy steps. Whether you're a first-time homeowner or just looking to upgrade your bathroom, this guide will have everything you need to get the job done right. Let us help you get started.

Bathroom Shower Installation

Before installing a bathroom shower, you will need to follow the following steps:

Prepping the Area

Before you can start installing your bathroom shower, you'll first need to prepare the area. Remove any clutter and make sure the floor is clean and free of any bumps or obstacles that might get in the way of installation.

Assuming you're installing your shower on a tiles or brick surface, it is necessary to first measure and mark the area where the shower pan will be installed. Standard shower pans are generally 24 inches wide by 36 inches long. Make sure to allow a 12-inch overhang on each side of the pan for drainage and safety reasons.

Next, mark out the measurements of your tiles or pavers using a level or straight edge. It is also important to determine how and where your shower head is going to be mounted as well as the route for the drain.

Installing the Shower Base

To install the shower base, start by installing the shower pan. Fit the pan into place and make sure it's level before securing it with screws or tile adhesive. Once you've installed the shower pan, start laying out your tiles or pavers.

You should ensure that each tile is centered precisely and that the tile adheres properly to the adhesive with a wet sponge. When you're finished, sand any irregularities off of your tiles or pavers before grouting them in place using a grout gun and mortar mix.

Installing the Shower Pipes

The shower base is now installed, and the next step is to start installing the pipes for the shower. Start by locating and cutting your pipe joints using a hacksaw or jigsaw. Once you've cut the joints, fit each piece of pipe into place and tighten the screws or tile adhesive until they're secure.

Next, route your drain tubing through both side of the shower pan and connect it to your taps or faucets. Finally, attach any necessary brackets or knobs before grouting them in place using a grout gun and mortar mix.

Finishing Touches

Once you've finished installing your shower, you should add some finishing touches to make the room look complete. First, paint or seal any unfinished areas around the pipes and joints with a coat of drywall compound or latex paint.

Then, add a sleek contemporary fixture such as Celtic faucets, rainhead spouts, or porcelain tiles. You are now ready to take advantage of the benefits of a relaxing bath after installing your new shower.

Conclusion

As a conclusion, installing a new shower is an easy task that can be completed by anyone with some basic DIY knowledge. Be sure to follow the instructions provided in this article carefully, and you'll have a perfect installation at hand in no time.